2025-01-21 13:37:50 send - data: 
 len:1
2025-01-21 13:37:50 read - data: 
2025-01-21 13:37:52 send - data: 
 len:1
2025-01-21 13:37:52 read - data: 
2025-01-21 13:37:54 send - data: 
 len:1
2025-01-21 13:37:54 read - data: 
2025-01-21 13:37:55 send - data: 
 len:1
2025-01-21 13:37:55 read - data: 
2025-01-21 13:37:57 send - data: 
 len:1
2025-01-21 13:37:57 read - data:                               
 

System startup
 
Uncompress Ok!

U-Boot 2020.01 (Nov 29 2023 - 17:09:21 +0800)47.8.7.14

DRAM:  Relocation Offset is: 1774b000
Relocating to 5ff4b000, new gd at 5feaadf8, sp at 5feaade0
 MMC:    sdhci-bsp: tuning done! valid phase shift [13, 12] Final Phase:28
MMC/SD Card:
    MID:         0x11
    Read Block:  512 Bytes
    Write Block: 512 Bytes
    Chip Size:   3776M Bytes (High Capacity)
    Name:        "004GA"
    Chip Type:   MMC
    Version:     5.0
    Speed:       200000000Hz
    Bus Width:   8bit
    Mode:        HS200
bsp-sdhci: 0 (eMMC)
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
    
Net:   gmac0
 Hit any key to stop autoboot:  3   0 
SD3403 # 
2025-01-21 13:37:57 send - data: reset
 len:6
2025-01-21 13:37:59 read - data: reset
resetting ...
                               
 

System startup
 
Uncompress Ok!

U-Boot 2020.01 (Nov 29 2023 - 17:09:21 +0800)47.8.7.14

DRAM:  Relocation Offset is: 1774b000
Relocating to 5ff4b000, new gd at 5feaadf8, sp at 5feaade0
 MMC:    sdhci-bsp: tuning done! valid phase shift [13, 12] Final Phase:28
MMC/SD Card:
    MID:         0x11
    Read Block:  512 Bytes
    Write Block: 512 Bytes
    Chip Size:   3776M Bytes (High Capacity)
    Name:        "004GA"
    Chip Type:   MMC
    Version:     5.0
    Speed:       200000000Hz
    Bus Width:   8bit
    Mode:        HS200
bsp-sdhci: 0 (eMMC)
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
    
Net:   gmac0
 Hit any key to stop autoboot:  3 
2025-01-21 13:37:59 send - data: 
 len:1
2025-01-21 13:38:00 read - data:  0 
SD3403 # 
2025-01-21 13:38:00 send - data: setenv serverip 192.168.192.151;
 len:33
2025-01-21 13:38:00 read - data: setenv serverip 192.168.192.151;
SD3403 # 
2025-01-21 13:38:00 send - data: setenv ipaddr 192.168.192.158;
 len:31
2025-01-21 13:38:00 read - data: setenv ipaddr 192.168.192.158;
SD3403 # 
2025-01-21 13:38:00 send - data: setenv uboot_name //UBOOT_47.8.7.17.bin;
 len:41
2025-01-21 13:38:00 send - data: saveenv;
 len:9
2025-01-21 13:38:01 read - data: setenv uboot_name //UBOOT_47.8.7.17.bin;
SD3403 #  saveenv;
Saving Environment to MMC... Writing to MMC(0)...  OK
SD3403 # 
2025-01-21 13:38:01 send - data: run update_uboot;
 len:18
2025-01-21 13:38:01 read - data: run update_uboot;

2025-01-21 13:38:02 read - data: 
2025-01-21 13:38:04 read - data: ETH0: PHY(phyaddr=1, rgmii) link UP: DUPLEX=FULL : SPEED=1000M
Using gmac0 device
TFTP from server 192.168.192.151; our IP address is 192.168.192.158
Filename '//UBOOT_47.8.7.17.bin'.
Load address: 0x42000000
Loading: *
TFTP error: 'Access violation' (2)
Not retrying...
SD3403 # 
2025-01-21 13:38:05 read - data: 
2025-01-21 13:38:07 read - data: 
2025-01-21 13:38:09 read - data: 
2025-01-21 13:38:10 read - data: 
2025-01-21 13:38:12 read - data: 
2025-01-21 13:38:13 read - data: 
2025-01-21 13:38:15 read - data: 
2025-01-21 13:38:17 read - data: 
2025-01-21 13:38:18 read - data: 
2025-01-21 13:38:20 read - data: 
2025-01-21 13:38:21 read - data: 
2025-01-21 13:38:23 read - data: 
2025-01-21 13:38:25 read - data: 
2025-01-21 13:38:26 read - data: 
2025-01-21 13:38:28 read - data: 
2025-01-21 13:38:29 read - data: 
2025-01-21 13:38:31 read - data: 
2025-01-21 13:38:33 read - data: 
2025-01-21 13:38:34 read - data:      
2025-01-21 13:38:36 read - data: 
2025-01-21 13:38:37 read - data: 
2025-01-21 13:38:39 read - data: 
2025-01-21 13:38:40 read - data: 
2025-01-21 13:38:42 read - data: 
2025-01-21 13:38:44 read - data: 
2025-01-21 13:38:45 read - data: 
2025-01-21 13:38:47 read - data: