2025-01-22 11:29:53 send - data: 
 len:1
2025-01-22 11:29:53 read - data: 
2025-01-22 11:29:55 send - data: 
 len:1
2025-01-22 11:29:55 read - data: 
2025-01-22 11:29:57 send - data: 
 len:1
2025-01-22 11:29:57 read - data: 
2025-01-22 11:29:58 send - data: 
 len:1
2025-01-22 11:29:59 read - data:                               
 

System startup
 
Uncompress  Ok!

U-Boot 2020.01 (Nov 29 2023 - 17:09:21 +0800)47.8.7.14

DRAM:  Relocation Offset is: 1774b000
Relocating to 5ff4b000, new gd at 5feaadf8, sp at 5feaade0
 MMC:    sdhci-bsp: tuning done! valid phase shift [13, 12] Final Phase:28
MMC/SD Card:
    MID:         0x11
    Read Block:  512 Bytes
    Write Block: 512 Bytes
    Chip Size:   3776M Bytes (High Capacity)
    Name:        "004GA"
    Chip Type:   MMC
    Version:     5.0
    Speed:       200000000Hz
    Bus Width:   8bit
    Mode:        HS200
bsp-sdhci: 0 (eMMC)
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
    
Net:   gmac0
 Hit any key to stop autoboot:  3   0 
SD3403 # 
2025-01-22 11:29:59 send - data: reset
 len:6
2025-01-22 11:30:00 read - data: reset
resetting ...
                               
 

System startup
 
Uncompress  Ok!

U-Boot 2020.01 (Nov 29 2023 - 17:09:21 +0800)47.8.7.14

DRAM:  Relocation Offset is: 1774b000
Relocating to 5ff4b000, new gd at 5feaadf8, sp at 5feaade0
 MMC:    sdhci-bsp: tuning done! valid phase shift [13, 12] Final Phase:28
MMC/SD Card:
    MID:         0x11
    Read Block:  512 Bytes
    Write Block: 512 Bytes
    Chip Size:   3776M Bytes (High Capacity)
    Name:        "004GA"
    Chip Type:   MMC
    Version:     5.0
    Speed:       200000000Hz
    Bus Width:   8bit
    Mode:        HS200
bsp-sdhci: 0 (eMMC)
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
    
Net:   gmac0
 Hit any key to stop autoboot:  3 
2025-01-22 11:30:00 send - data: 
 len:1
2025-01-22 11:30:01 read - data:  0 
SD3403 # 
2025-01-22 11:30:01 send - data: setenv serverip 192.168.199.100;
 len:33
2025-01-22 11:30:01 read - data: setenv serverip 192.168.199.100;
SD3403 # 
2025-01-22 11:30:01 send - data: setenv ipaddr 192.168.192.158;
 len:31
2025-01-22 11:30:02 read - data: setenv ipaddr 192.168.192.158;
SD3403 # 
2025-01-22 11:30:02 send - data: setenv uboot_name /CCTV_burn/1.CCTV_image/UBOOT_47.8.7.17.bin;
 len:63
2025-01-22 11:30:02 send - data: saveenv;
 len:9
2025-01-22 11:30:02 read - data: setenv uboot_name /CCTV_burn/1.CCTV_image/UBOOT_47.8.7.17.bin;
SD3403 #  saveenv;
Saving Environment to MMC... Writing to redundant MMC(0)...  OK
SD3403 # 
2025-01-22 11:30:02 send - data: run update_uboot;
 len:18
2025-01-22 11:30:02 read - data: run update_uboot;

2025-01-22 11:30:04 read - data: 
2025-01-22 11:30:05 read - data: ETH0: PHY(phyaddr=1, rgmii) link UP: DUPLEX=FULL : SPEED=1000M
Using gmac0 device
TFTP from server 192.168.199.100; our IP address is 192.168.192.158; sending through gateway 192.168.62.1
Filename '/CCTV_burn/1.CCTV_image/UBOOT_47.8.7.17.bin'.
Load address: 0x42000000
Loading: *
2025-01-22 11:30:07 read - data: 
2025-01-22 11:30:08 read - data: 
2025-01-22 11:30:10 read - data: 
2025-01-22 11:30:12 read - data: 
2025-01-22 11:30:13 read - data: 
2025-01-22 11:30:15 read - data: 
2025-01-22 11:30:16 read - data: 
2025-01-22 11:30:18 read - data: 
2025-01-22 11:30:19 read - data: 
2025-01-22 11:30:21 read - data: 
2025-01-22 11:30:23 read - data: 
2025-01-22 11:30:24 read - data: 
2025-01-22 11:30:26 read - data: 
ARP Retry count exceeded; starting again
 SD3403 # 
2025-01-22 11:30:27 read - data: 
2025-01-22 11:30:29 read - data: 
2025-01-22 11:30:31 read - data: 
2025-01-22 11:30:32 read - data: 
2025-01-22 11:30:34 read - data: 
2025-01-22 11:30:35 read - data: 
2025-01-22 11:30:37 read - data: 
2025-01-22 11:30:39 read - data: 
2025-01-22 11:30:40 read - data: 
2025-01-22 11:30:42 read - data: 
2025-01-22 11:30:43 read - data: 
2025-01-22 11:30:45 read - data: 
2025-01-22 11:30:46 read - data: 
2025-01-22 11:30:48 read - data: